The wall in our garage next to the house entrance has some issues. Multiple things had been attached and removed, and there was once a dart board. The result is a serious amount of holes. There are a lot of things I want to attach to this wall. They are often too small to use french cleats and I don’t want a million wall anchors. Why not use wood?

I picked up a pile of tongue and groove pine and covered the outward face in boiled linseed oil (BLO) to offer a little color and basic protection.

Everything got pulled away from the wall and I put in the first slat. I made really sure the first one was tight up against the wall and level. After that, things went pretty smoothly. I worked my way up the wall and got to some outlets that were disused. The house had a number of intercoms that were removed, phone jacks, and some switches I don’t need any more. I went through and measured everything’s position and saved it so I can reopen those boxes again if I want them in the future.

I put a corner mold on the outside edge and used a little scribe piece of pine to help smooth the transition between the door mold and the wood wall.

• 

• 

With everything up I could accessorize a bit. I bought wooden switch plates so the light switches and outlet would look nicer and blend in better.

• 

• 

---

3D Printed Enhancements

As I stated earlier, part of the reason for doing this is to support mounting options. I have a remote for my new AC system, an indoor/outdoor thermometer and a remote for the ceiling dust filter. The AC remote already had a mounting bracket, the others had to be designed and printed

• 

• 

While taking the garage door wall controls off the wall, the plastic started coming apart. The clips were breaking off and screw holes splitting. I printed a cradle that the housing would fit in and offer new mounting screw holes. The bodies were bonded into the cradle and allowed to cure overnight. The only place I had access to screw holes was under the main button. The base is thick enough to keep it from flapping under use.

• 

• 

• 

• 

---

I continued to add the signs and other accessories to my wall as I put the desk back and cleaned up. I was able to mount my shiny red metal first aid kit down low in easy reach. I also screwed a sealed CAT tourniquet to the wall. Hopefully that never comes in handy. Having the wall here has been nice. The space feels a lot warmer, and I have already added more items since taking this picture. I might pick continue this theme elsewhere in the shop, but not any time soon.