Kilted Craft Works

Let's make something!

Drill Powered Honey Spinner Demonstration

Posted on June 26, 2016 by Chase

I have gotten a lot of activity related to my Drill Powered Honey Spinner. In fact probably 90% of all the traffic I have ever received has been to that post. I guess it was a good idea! My explanation was pretty good, but could really be supplemented with a nice video. I finally found the time to shoot and edit one, so enjoy and thank you for watching.

5 thoughts on “Drill Powered Honey Spinner Demonstration”

Rosemary Bonadies on June 26, 2016 at 11:05 pm said:

Liked the intro and ending music also. Good idea to share it this way too. R and B

LikeLike

Reply ↓
Alicia on September 9, 2023 at 7:59 pm said:

Did you prime the PVC before you glued it?

LikeLike

Reply ↓
- Chase on September 9, 2023 at 8:18 pm said:
  
  No, I never have in any of my plumbing adventures. It hasn’t been a problem yet.
  
  LikeLike
  
  Reply ↓
  - Alicia Dekeyzer on September 10, 2023 at 8:38 pm said:
    
    Thanks, and one more question. Did you make the central hole that the spinning part sits in 7/8 or 3/4 ?
    
    LikeLike
  - Chase on September 11, 2023 at 5:13 am said:
    
    It needs to be big enough for the PVC to fit through. If you used 3/4″ pvc, that will be a little over an inch. A step drill bit or forstner bit can help get you there.
    
    LikeLike