Lots of good prints this month. I have got the new printer pretty well figured out and have ventured out into new materials and longer prints. First up is a cool blade guard I made. I picked up this nice boning knife for bbq goodness. It is crazy sharp but came with no guard. I printed a two piece guard with magnets set into the one half. The two bits glue together. It keeps the edge and my fingers safe and fits snuggly.
Porch Cup Holder
I have some Adirondack chairs on the back porch. They are reasonably comfortable, but have a distinct lack of cup holders. I fashioned some a while back out of wood, but the sizing was all wrong. These are perfect. They hold coffee cups, large tumblers and small glasses alike. The RTIC’s blue handle was printed back in September and is still alive after daily use. Thingiverse Link
I got a cheap thermocouple reader for reasons beyond my obsession with measurements… I swear. It works well, but didn’t come with a kickstand. I am used to all my multimeters having some way to sit themselves upright. This one clips together, then slides on snugly. It doesn’t add too much bulk and stands steady.
I have a few high temperature projects, so it is time to venture beyond the safety of PLA. It is a great material to print with, but loses strength quickly when things get hot. Enter PETG. It is higher temp and strength like ABS, but less toxic, and lower warping. One of my firsts was the Franken-Cooler. Not without issue, but largely a success.
Next I made a small clip to keep the USB cables in my car in order. They always get pinched in the lid when I close my center console. This will keep them in the pass through. Simple but effective. I needed the higher temp material because cars get hot in Florida.
I made some mods to the camera setup on my prusa. Someone made a decent set of parts to attach a common webcam to the Y stage. The only problem is their main bracket was a bit loose. I started with PLA because that was all I had. It sits up against the underside of the heated bed. If I need higher bed temps the part could fail. I designed a lighter tighter fitting version with speed holes to help cord wrangling. The PETG part will not fail due to excessive bed heating.
While I was at it I found a lens adapter that could replace the original webcam lens with a very wide angle one.
The new lens give a much better view of the print bed. I can see the whole thing instead of just the middle third.
Finally I can take time lapse videos that don’t look terrible. Behold the birth of a baby groot.